Tuotteen HMG Coach Enamel arvostelut

HMG Coach Enamel is a traditional, ultra high quality, high build, long oil synthetic enamel for brush application.  It gives an extra long wet edge time allowing it to be brushed without brush drag. Click To Jump To Section: Features & Benefits Product Specification Film Thickness Range And Coverage Drying Times Surface Preparation Application Methods Product Notes Health & Safety Features & Benefits High gloss Excellent water resistance Flexible with good exterior durability and toughness Available in 3,500 colours from RAL, NCS, and British Standard Product Specification Technical Data Volume Solids: 58.8% VOC Content: 0.380kgs/ltr SG: - Viscosity: 250 mPas Density: 1.055 g/cm³ Storage Conditions: Store between 5°C - 25°C. When not in use, cans must be kept sealed. Shelf Life: 12 months from delivery date in original sealed containers. Flash Point: - 42°C Film Thickness Range And Coverage Product Data   Dry Film Thickness Wet Film Thickness Brush: 50 µm 100 µm Coverage: 10 square metres per litre @ 50 microns dft. HMG technical data sheets indicate a dry film thickness that will be achieved when applying a particular wet film thickness. These values are a guide only and are not to be used as specifications. Film thickness will vary depending on actual use and specification. Great care should be taken to achieve the dft stated in the agreed specification and to avoid areas of excessively low or high thickness. Drying Times Drying Times At 20°C Touch Dry: 3 hours Dry To Handle: 12 hours Dry To Recoat: After 24 hours Fully Cured: 24 hours Surface Preparation Ensure surfaces to be coated are dry and must be cleaned using the appropriate HMG product to remove all traces of contaminants. Application Methods Technical Data Brush Mixing Ratio: Thinner: Up to 10% - Thinner Options: Thinner 2611 Thinner 2612 Viscosity: 250 mPas Number Of Coats (Guide Only): 1 - 2 coats Flash Off: - Product Notes Information on basic physical and chemical properties Form: Liquid Colour: According to product specification. Odour: Characteristic Odour Threshold: Not determined pH-value: Not determined Change in Condition Melting point/freezing point: Undetermined Initial boiling point and boiling range: 135°C Flash Point: 30°C Flammability (solid, gas): Not applicable Ignition temperature: 200°C Decomposition temperature: Not determined. Auto-ignition temperature: Product is not selfigniting Explosive properties: "Product is not explosive. However, formation of explosive air vapour mixtures are possible." Explosion limits: Lower: 0.6 Vol % Explosion limits: Upper: 7 Vol % Vapour pressure at 20°C: 2 hPa Density at 20°C: 1.062 g/cm³ Relative density: Not determind Vapour density: Not determind Evaporation rate: Not determind Solubility in / Miscibility with water: NOT MISCIBLE Partition coefficient: n-octanol/water: Not determined Viscosity: Dynamic at 20°C: 250 mPas Viscosity: Kinematic: Not determined Solvent content: Organic solvents: 40.9% Solids content: 58.8% Health & Safety Refer to the safety data sheet in the attachments section above and tin label prior to use. Suitable respiratory equipment should be worn when spraying. Contaminated rags, spray booth filters or other substrates should be segregated from other chemical waste, soaked with water and disposed of in a noncombustible container with a tight fitting lid. Click to go back to the top of the page