Lanoguard  Arvostelua 

There is good and not so good with this product. The grease is a very good product and has good staying properties, it though due to its viscosity doesn't creep so no good for crevices. The liquid is better for crevices but after a few months it's been washed off by spray, pressure washing or even road debris so you have to redo this treatment at least annually. It's also far too expensive and the cavity applicator is a joke. It looks good on initial application but a under a year later its all gone and corrosion has started again. There are other lanolin based products that last for 5 years without reapplication and are cheaper and that's what I'm now using.

I have used lanoguard on my ssangyong rexton, a full bottle did it all the underside including tip & bottom of the fuel tank, very impressed & will be doing it again before winter just to make sure

Absolutely amazing products and great service!

Can’t fault this product, I’ve bought this a few times too cover 3 vehicles including a van. Living in salt covered roads and next too the sea, this is a must. Sparky a tow bar 3 years ago when it was new, it’s still like new nice and black so this proves it works

I have just purchased my first 4x4 (not a new one) and wanted some kind of under seal treatment, I then saw “Lanoguard”. Ordering couldn’t have been easier and I was kept informed on delivery (very friendly people) on using I couldn’t be happier !! goes on a real treat with no horrible smell
5 Stars all the way 👍👍👍
Thanks guys
D.Robinson

I paid £90 for the 2ltr kit with 2 spray guns, applicator bottle and cavity injection wand.
The product itself goes on very well and soaks into the rust and crevices and dries after about 48 hours.
That's the good, the bad - its expensive for what you get, the product needs re applying every 12 months, so not a one time job as with a product like bilt hamber for example, the applicator spray guns are frustratingly intermittent, and the cavity lance is next to useless for rust proofing cavities, it squirts 4 jets at 90 degree angles, you need a fine mist spray to get coverage.
I contacted Lanoguard before reviewing the product and was advised it was a faulty spray lance,(its not faulty its a pipe with 4 holes drilled in the end) but to get a replacement i would have to contact the 3rd party i purchased the original kit from - who were very helpful. They advised that the lance was working correctly, it is supposed to spray 4 jets and not a mist pattern.
So in summary - the product itself does the job and applies well, the spray guns when working give a good mist coat, and injection lance (the main reason i bought the kit) is useless.

Come on lanoguard ! this could be a great product if you sort out the sprayers.

Would i buy again, no i would stick with Bilt Hamber.