Revolubes Arvostelua 

Excellent product, quick delivery.

I was sceptical about revolubes claims and the first time i applied it i didn't read the information. When it's done correctly it works a treat, your chain looks clean, rides smooth and quiet. Three weeks later and the chain is still clean. When applying to each link don't squeeze hard on the applicator, just touch each link and lightly apply or you will waste some lube as it is quite thin. It's a good idea to clean and lube your chain 12/24hrs before riding and let the magic work.

It works really well and is a lot less messy than oil. It's barely rained in the last 2 months so can't comment on its wet weather capabilities, recommended.

Re purchase as I’ve been very impressed using it on all my bikes

I have fitted new chains to two of my bikes: my road bike and the bike I use on my indoor trainer. I used white spirit and then petrol to dissolve the manufacturer’s grease and applied Revolube before fitting the chains. I’m extremely pleased with the results. Objectively, the chain noise is much reduced, and subjectively the drive on both bikes seems smoother and it feels like more of my power is being applied to the rear wheel. I’ve done around 200 km outdoors and about the same indoors over the last two weeks and both chains look pristine - only a little rain outside over that period as I rode inside on the rainy days.

I discovered that all three chains were at or even over their wear limit after only about 3000 km, so am hoping that the life of the new chains will be a lot longer. I had a couple of spare chains I could fit immediately and had to send for a chain for my cross bike. I’m not riding that at the moment because of the risk of meeting other riders on narrow tracks but have flushed and lubricated the new chain with Revolubes ready to fit when I have a minute.

I should also say that I used the bearing grease to lubricate the tension assembly on my Assioma Favero Duo pedals and found that it greatly improved the clipping out, which could be a little fraught with these pedals.

The dropper works very well and makes it easy to apply the right amount, as well as promising that the bottle of lubricant will last a long time.

Only been on the bike once since using the Revolube and there definitely less friction and the drivetrain is much smoother. Would use a new chain next time though as it is difficult to get a old chain 100% clean

I've waited for a month before I posted a review, as I wanted to give Revolubes a fair and decent trial first. I purchased the dual offer pack of the lube and grease and boy am I impressed. I followed the instructions meticulously (not that they're complicated, I might add) on how to apply the Revolubes products and well what can I say.
Absolutely outstanding! I have NEVER known my road bike to run so smoothly!
The bearings are totally silent and I have never known the gears to change so smoothly and indeed very quietly.
All in all a brilliant product that I will thoroughly recommend to every cyclist that I know.
So we'll done Revolubes, I am one very happy customer and as Arnie would say, I'll be back 👍🙂

Great product. Delivery a bit slow but it finally came, as described.

Great product. Used it all the bikes in the house. Smooth running drive train on all of them. Recommend this product

wanted a clean(ish) lube for the drivetrain on my road bike..will never use wet oil due to constant cleaning to eliminate the grinding paste effect..been using dry lube which does the job okay but any rain at all and soon washes off to almost zero lubrication..recieved the revolube and cleaned chain as instructed..applied and have covered 180 miles in 4 rides..drivetrain nice and quiet tho after 1st 2 rides did wipe off some excess (i was maybe a little generous with the size of droplets required)..wipes of easily and comes up clean..not ridden in any rain as yet so jury out on that one..all in all seems really good..not too sure how often or how many miles covered before i should reapply..but yes very good so far

Running for a few months now
Not really seen any benefits
On my chains ( Rotor Uno KMC X11SLC DLC ) chains stay wet, pics up grime
Cleans easy, but then pics up grime again
For the cost, Ive seen better results out of cheaper dry lubes

Average at best
Still 3/4 bottle left, and will still be there next year.

Also tried the new grease, thats just plain rubbish.... so thick, bearings became really stiff, spoke with Revo Guy, advised after looking into it 75% fill, then when I spoke again about how bad they were changed that to a 25% fill for BB bearings
End result 3 rides later stripped and cleaned grease went in the bin.
Certainly not a friction lube for bearings
Probably ok for outer use, but friction wise.....
Not for me
Bearings for ref are NTN 6805 LLB Ultra Low Friction seal ( not with this grease )

Revolube arrived Saturday and I applied it after a bike ride that afternoon, on my bike ride the following day, gears and gear changes were a lot smoother, very impressed.

I received the bottle of lube yesterday, definitely a brilliant and easy way to apply via the applicator (less drips/waste).
I haven't ridden with it applied yet but I have great hopes for it and would 100% recommend it to other riders.
Excellent

Good instructions with details on how to clean chain and apply Revolube

I’ve been keen to sort out my working solution for a smooth running clean chain for sometime. I definitely want to drop the sticky as hell ceramic gloop that may give for smooth running mechanicals but makes for a honey pot of a chain for any suspecting road grim and metal filings. So I went for the more than thorough route to clean my chain pre 1st application of Revolube. Chain off, looped onto and old coat hanger and into a old ice cream punnet of firstly petrol, 8hrs of a regularly agitated soak was effective complete with a thorough brush scrub on all four sides, then out of stage 1 and into a chain cleaner punnet. While in for less time and a bit more brushing it’s now looking clean and so into the 3rd stage punnet with a splash of isopropyl and I had a chain I could eat my dinner off! All the gears were likewise carefully cleaned with chain cleaner and then when all was dry the Revolube was applied as per the guidance and wiping the excess and away we flew down the road (in my mind anyway). Maybe my chain wasn’t quite as pristine at the end of the 50 miler as it was beforehand, but it was definitely better than any other lube I’ve used for sure and yes, there was neither a squeak nor a graunch from the mechanicals. Early days, but things are looking up!

Fast delivery, haven't used yet but will review once I do.

After the initial clean and application as described, I found my first ride a little disappointing as the drivetrain was really noisy. My groupset is Dura ace so I put the noise down to the different materials the cassette is made from and the viscosity of the lube. I decided to inform Revolube as my normal lube was much quieter. They suggested I continue to re-apply before each ride until the lube worked it’s way In between the rollers. Archie kept in touch by e-mail on my progress and I’m now happy to report that I’m now fully satisfied with the noise levels and the ease in which my cranks spin. Thank you for your persistence Archie because without that I may have given up on the lube..

Early days but rode over a 100 miles mostly road a bit of gravel and dirt smooth and slick .

Super smooth and doesn't attract dust, RECOMMENDED